Heat Treating & Blackening in Newport, PA
NTM handles small parts heat treating and blackening in-house at our Newport, PA facility. By keeping standard finishing on one floor, we eliminate the delays and coordination problems of sending every part out. Specialty processes outside our in-house capabilities are routed to trusted partners. From single prototypes to full production runs, your parts move efficiently from first operation to final delivery.
NTM handles small parts heat treating and blackening in-house at our Newport, PA facility. By keeping standard finishing on one floor, we eliminate the delays and coordination problems of sending every part out. Specialty processes outside our in-house capabilities are routed to trusted partners. From single prototypes to full production runs, your parts move efficiently from first operation to final delivery.
NTM has delivered small parts heat treating and blackening in Newport, PA since 1972. When you bring a job to NTM, you sit down directly with the people who will build your part. There are no corporate layers, no account managers, and no runaround.
As a result, every decision from setup to final inspection stays with the same team from start to finish.
How heat treating and blackening works at NTM
Drawing Review
We review your drawings, or build one with you in SolidWorks if you're starting from scratch, so every process decision is built around your finish requirements.
Process Planning
Because heat treating and blackening both run in-house, we coordinate routine finishing without sending your parts off-site. For specialty processes outside our capabilities, we partner with trusted vendors we’ve worked with for years, so your job still moves efficiently.
Processing
Your parts run through heat treating, blackening, or both, depending on what your drawing requires, with the same team from first operation to last.
Inspection
Every order ships with documented inspection using Geo Met 101 and CMM Manager. Nothing leaves NTM without a record.
Can one shop handle this from prototype to production?
Yes, and at NTM, both run on the same floor with the same team. There's no gap between the person who ran your prototype and the team running production. If a drawing needs to change between the two, we make that adjustment before a single production part runs.
Contact Us TodayHow do I know my finished parts will meet spec?
Every heat treating and blackening order at NTM ships against an ISO 9001:2015 certified inspection process valid through 2029. Smaller runs receive full inspection across every piece. Larger production orders follow a documented chart that scales with volume. Nothing ships without a record.
Frequently asked questions
Ready to start your project?
NTM has delivered small parts heat treating and blackening in Newport, PA for more than 50 years, both handled in-house so your job stays on one dock. Whether you're starting with a drawing or from scratch, we're ready to work.